Fixes and more fixes

Well after the disaster of the MOT test I had lots to deal with. Most of it was minor, but some required thought and planning. The key issues are as follows:

1. The Rear shock linkage is terrible and needs doing correctly
2. The shock itself is old and knackered
3. The front mudguard is not one for this bike and isn’t secured correctly.
4. The rear light is playing up.
5. The brake torque arm is attached by a bolt not giving it movement
6. Footrest are insecure.

Just a few jobs then. I’ve got to work on these in turn.

1. The shock linkage was replaced at some point with sheet metal instead of the correct dogbones. I’ve got a second hand shock linkage from eBay which will need fitting. You can see the issue below. I didn’t catch it as I didn’t look under the bike right there. It’s passed mot’s before which is worrying!

2. The shock is very old now and finding a better alternative was the best plan. I’ve search around to find a suitable second hand alternative, without decent success. So I bit the bullet and ordered a new shock. Its a YSS one and was well priced. They are making it for me now. Once it’s arrived I can fit it and the dogbones.

3. The mudguard was easy. It can pass the mot without one. So I removed it. I’ve ordered a replacement from Skidmarx. That will arrive in a couple of weeks. In the meantime it looks much cooler without the mudguard!

4. The rear light was an odd one, I swore it was working, but I was wrong. It’s not lighting up properly. I tried loads of things, but I worked out in the end that the light had broken. Very annoying. I thought about getting a replacement, but my faith in that lasting wasn’t good. So I looked for alternatives. In the end I found a combined indicators/brake/rear light system that is in a tiny cnc strip.

The seller was in Australia and it arrived in less than a week! I was amazed. I started testing it to make sure it worked.

As this light sticks to the number plate I also needed a number plate light. I found a tiny cnc number plate light on ebay and had to have it.

With both of these changes I had to remake the number plate bracket. I’ve spent the last couple of days knocking this up, It needs the light mounting to the number plate, but it’s close to being done.

5. The bolt was a right bodge job and needed me to source the proper torque bushing. I managed to find a new one which was good. I need to fit it tomorrow.

6. The footrests were using too small a bolt as the eyes of my cnc footpegs were smaller than the originals. I drilled out the the holes and fixed a larger bolt in place. You can also see the new oil cap I found going cheap on ebay.